EN LOCAL AIR CONDITIONER OPERATING INSTRUCTIONS Read the instructions carefully before operating the appliance or carrying out maintenance work. Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or damage. Keep these instructions in a safe place for future reference.
GENERAL OPERATING AND SAFETY INSTRUCTIONS • • • • • • • • • • • • • • • This appliance is a portable air-conditioner, designed for domestic use. Only use this air-conditioner as described in this manual. Ensure that the required voltage and frequency (220-240V/50Hz) match the available power supply. Ensure that the electricity system is able to deliver the operating current needed by the air-conditioner in addition to that normally absorbed by other appliances (electrical appliances, lighting, etc.).
INSTRUCTIONS TO REMOVE THE PACKAGING 1. 2. 3. 4. 5. Place the unit in the correct upright position before unpacking. Cut the two packing straps. Slide the carton upwards and remove the product from the base. Pull from the bottom of the package, the flexible hose, the terminal connector (divided in two parts a and b) and the connector with the magnet to be placed on the unit to connect the hose. Install the exhaust hose on the unit before operating the unit in Cooling mode.
APPLIANCE START-UP Elements supplied with the unit (shown in the box here below). Slim Remote control Connector with magnet to be placed on the hot air outlet on the unit, after having connected the flexible hose, complete of the terminal flat connector. Battery for remote control Type CR2025- 3V - Lithium. Flexible hose for hot air expulsion Terminal flat connector to be connected to the flexible hose and to be placed between the window leafs.
USE WITH TERMINAL CONNECTION FOR WINDOW Connect the end part of the flexible hose (5) to the flat connector (4). Open the windows and block one of the two leafs with the handle. Rest the terminal connection on the fixed leaf, bring the other leaf of the window close. Avoid tight curves and folds in the flexible hose. Connect the power cord to a suitable electrical socket (220-240V). HOW TO USE THE APPLIANCE This appliance can be used to Cool, Dehumidify and Ventilate.
OPERATING MODES & MODE SELECTION 1. COOLING MODE Press the key Power on the control panel or on the remote control to enter into Cooling mode far left on the upper ring of the unit will light, indicating Cooling mode operation. Then select the ventilation speed, pressing on remote control keys corresponding to the low speed. ; the white LED at the , medium or high 2.
Cooling To empty the tank, switch the air conditioner off and unplug it. Remove the drainage hole cap at the bottom on the right and connect a little tube through which drain the condensate; place the other end on top of a normal reservoir. Ensure that the tube is not twisted or bent. The tube must slope downwards. Close the drain again with the cap and restart using the air conditioner.
REMOTE CONTROL BATTERY Insert the battery into the remote control, respecting polarities specified. Only use type CR2025 batteries 3 V Li, in accordance with European Directive 2006/66/EC (supplied with the remote control). Remove the battery if the remote control is not used for a month or longer. Do not attempt to recharge the battery. Do not throw the battery onto a fire, it may explode.
3. Storage. When you do not envisage using the air-conditioner for a long time, before storing it away, clean the filters. Keep the appliance in a vertical position at all times. Do not rest heavy objects on the top and, if possible, protect the air-conditioner with a sheet of plastic. 4. Transport. If possible, transport the air-conditioner in a vertical position.