Operation Manual

13
V 01/17
CONTROL PANEL
POWER
Connect unit to supply: you can hear a beep and all the LEDs flash. The LED on AQI button flashes for 3" taking various
colors: blue, orange and red.
After two minutes the sensor is ready to work: all the LEDs turn off except the POWER one and the unit is on standby.
ON/OFF BUTTON
Press this button to turn on the unit in AUTO mode. The sensor needs two minutes to be able to work consistently:
during this time the fan speed is set on medium speed (orange LED). Then the unit automatically adjusts the fan speed
according to air quality and the LED AQI will assume the corresponding color.
COLOURING ACCORDING TO THE AIR QUALITY IN AUTO MODE
Air quality Good Medium Bad
LED colour Blu Orange Red
Fan speed Low Medium High
Press this button again to turn off the unit (stand by) and all the LEDs turn off.
TIMER BUTTON
Press this button to set the timer from 1h to 8h.
SPEED BUTTON
Press this button to adjust the fan speed according to the following sequence: AUTO – LOW – MID – HIGH.
AUTO:
In AUTO mode, the fan speed is set initially on medium speed (orange LED). After 120 ", the unit automatically adjusts
the fan speed according to air quality and the LED AQI will assume the corresponding color.
SLEEP BUTTON
1. Press this button for the appliance to operate more silently. The fan speed will be set to the minimum speed.
2. When the light of this button blinks the carbon filter and the HEPA filter may need to be replaced. Press the sleep
button for seconds after changing the filters and the light stops blinking.
ANION BUTTON
Press this button to turn on or turn off the emission of negative ions.