EN CERAMIC FAN HEATER URBAN OPERATING INSTRUCTIONS Read the instructions carefully before installing and operating the appliance or performing maintenance operations. Observe all the safety instructions; failure to observe the instructions may cause accidents and/or damages. Store these instructions for future reference.
GENERAL SAFETY INFORMATION Use this fan heater only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to people. Ensure that the mains power complies with the voltage specified on the fan heater data plate (220-240V ~/50Hz).
automatically, as there may be a risk of fire if the fan heater is covered or incorrectly positioned. Do not restrict the air inlet and outlet grilles. The appliance heats up slightly when in use. In order to avoid burns, do not let bare skin touch hot surfaces. Ensure that all objects are at least 1 meter from the front and sides of the appliance. Disconnect the mains power when the appliance is not used or for cleaning operations.
soapy water. Always remove the plug from the mains socket before cleaning. To disconnect the fan heater, push the switch to OFF and remove the plug from the socket. Pull on the plug only. Avoid pulling on the cord when disconnecting the fan heater. Do not place any objects on the cord and do not bend it. It is not advisable to use extension cords, as these may overheat and cause the risk of fire. Do not use a single extension cord to operate multiple appliances.
Upon initial start-up, the fan heater may emit a slight, harmless smell. This smell is a normal effect of the initial heating up of the internal heating elements, and should not recur later on. WARNING: DO NOT DEPEND ON THE ON/OFF BUTTON SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER. WHEN SERVICING OR MOVING THE FAN HEATER, ALWAYS UNPLUG THE POWER CORD. A fan heater has hot and arcing or sparkling parts inside.
DESCRIPTION OF PARTS 4 1 7 5 3 6 2 1. 2. 3. 4. 5. 6. 7. Air outlet grill Operating LED Base of the appliance Control panel Air inlet grille Anti tip-up device Dust filter HOW TO USE THE FAN HEATER Put the fan heater vertically on a flat and stable surface. Use the handle when you move the appliance. Connect the power cord to a suitable electric socket (220-240V ~/50Hz). Turn the thermostat knob clockwise to maximum position.
CONTROL PANEL AND AVAILABLE FUNCTIONS ECO mode 1: 1000W reduced power and consumption to save energy. Thermostat adjustment knob: from Minimum to Maximum temperature, by turning the knob right to left. COMFORT mode (2): maximum heating power: 2000 W OFF: fan heater OFF ECO mode 2: 1000W reduced power and consumption to save energy. The thermostat maintains the desired room temperature by automatically switching on/off the fan heater. As you rotate the knob left, the room temperature increases.
Monthly cleaning the air filter, if necessary. Remove the air filter for cleaning. If the appliance is cleaned with water, make sure that the air filter is dry before re-installing it onto the appliance. INFORMATION FOR THE CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EUROPEAN DIRECTIVE 2012/19/EU This appliance may not be scrapped with domestic waste at the end of its life cycle.
