Operation Manual

V 11/15
18
Step six: install the condensate drain pipe
Connect the drain pipe to the outlet pipe of the
indoor unit.
Bind the joint with tape.
N.B.:
• Add an insulating tube to the indoor drain pipe to
prevent condensation.
• The plastic wall plugs are not supplied.
tuboisolante insulating tube
tubo di uscita outlet pipe
tubo di scarico drain pipe
nastro tape
Step seven: connect the indoor unit electrical cable
1. Open the panel. Remove the screw that
secures the small panel covering the terminal
board.
coperchio cablaggio
vite
pannello
2. Insert the indoor and outdoor unit connecting
cable into the rear hole corresponding to the
terminal block. Then pull it out of the front.
cavo di
alimentazione
foro di
passaggio
cavo
pannello panel
vite screw
Coperchio cablaggio wiring cover
foro di passaggio cable
cavo through-hole
cavo di alimentazione power cable
3. Remove the cable clip. Connect the power cable to the terminal block according to colour.
Tighten the screw and secure the power cable with the clip.
blu blue
nero black
marrone brown
giallo-verde yellow-green
Collegamento unità esterna Outdoor unit connection
4. Reposition the terminal block cover and tighten the screws.
5. Close the panel.
tubo di scarico
nastro
tubo d'uscita
tubo di
uscita
tubo di scarico
tubo di scarico
tubo isolante