Operation Manual

V 11/15
6
• When you press the ON/OFF button on the remote control, the icon on the remote control
display will flash once and the air conditioner will emit a beep. This means that the signal has
been sent to the unit.
• When the unit is off, the temperature will be shown on the remote control, the correspondent icon
will appear. If the unit is on, you will see the icon of the correspondent mode.
1. ON/OFF button
Press the ON/OFF button to turn the air conditioner on or off.
2. MODE button
Press this button to select the desired operating mode.
After selecting the mode, the correspondent light will turn on.
AUTO - COOL - DRY - FAN - HEAT
When you select automatic mode, the air conditioner will operate automatically according to the
factory settings. The set temperature cannot be adjusted and will not be displayed. Pressing the
"FAN" button will allow you to adjust the fan speed.
When you select cool mode, the air conditioner will run in cool mode. The cooling indiicator will
illuminate on the display. Press "+" or "-" to adjust the set temperature. Press the "FAN" button
to adjust the fan speed.
When you select dry mode, the air conditioner will run at low speed in dry mode. The fan speed
cannot be adjusted in this mode.
When you select fan mode, the air conditioner will operate only the fan, blowing air without
cooling or heating. Press the "FAN" button to adjust the fan speed.
.
When you select heat mode, the air conditioner will run in heat mode. Press "+" or "-" to adjust
the set temperature. Press the "FAN" button to adjust the fan speed.
3. +/- Button
Press "+" or "-" once to increase or decrease the set temperature by 1°C. Press and hold "+" or
"-" for 2 seconds to rapidly adjust the set temperature on the remote control. When set-up is
complete, release the button and the indoor unit's temperature indicator will change
accordingly.
When setting the TIMER ON, TIMER OFF, press "+" or "-" to adjust the time. (Please refer to
the relevant sections for TIMER ON and TIMER OFF buttons).
4. FAN button
Pressing this button will allow you to cycle through and set the fan speed: automatic AUTO,
SPEED 1 (
), SPEED 2 ( ), SPEED 3 ( ), SPEED 4 ):
AUTO -
- - -
Note that when you select AUTO, the unit will automatically select the most suitable fan speed
according to the factory settings. The fan will operate at low speed in dry mode.
5. SWING button
Press this button to turn on or off the oscillation of the flaps.
6. SLEEP button
In the cooling, heating and dehumidification modes, press this button to activate the sleep
function. Press this button to cancel the Sleep function. In the FAN and AUTO mode, this
function is not available.