Operating Instructions and Installation Instructions

V 03/17
42
Pressing this button will allow you to cycle through and set the fan speed: automatic (AUTO),
low (
), medium ( ) or high ( ).
N.B.:
When you select AUTO, the unit will automatically select the most suitable fan speed according
to the factory settings.
The fan will operate at low speed in dry mode.
6. SWING button
Press this button to set the swing angle (up/down). You can cycle through and set the fan's
angle of airflow as shown below:
nessuna
visualizzazione
(il deflettore orizzontale si arresta
nella posizione corrente)
nessunavisualizzazione(ildeflettoreorizzontalesiarrestanella
posizionecorrente)
nodisplay(thehorizontalflapstopsinthecurrentposition)
 When you select , the air conditioner will operate the fan automatically. The horizontal flap
will automatically tilt up and down to the maximum angle.
 When you select
, the air conditioner will operate the fan in a fixed position.
The horizontal flap will stop in a fixed position.
 When you select
, the air conditioner will operate the fan at a fixed angle. The
horizontal flap will deliver air at a fixed angle.
 Hold and press the
button for 2 seconds to set the desired tilt angle. Release the button
once you have reached the desired angle.
N.B.:
 may not be available. When the air conditioner receives this signal, the fan will
start operating in automatic mode.
7. I FEEL button
Press this button to start the I FEEL function. The icon will appear on the remote control
display. When you select this function, the remote control will send the detected ambient
temperature to the indoor unit, which will then adjust its operation automatically based on the
difference between the detected temperature and the set temperature.
Press the button again to exit the I FEEL function. The
icon will disappear from the display.
The remote control should be positioned near the user when this function is selected.
The remote control should not be placed anywhere high or low temperatures may occur
to avoid inaccurate ambient temperature detection.
8. HEALTH/AIR button
Press this button once to start the air purification function. The icon will appear on the
display. Press the button a second time to start the purification and sanitisation function
simultaneously. The
and icons will appear on the display.
Press the button a third time to turn off both functions.
Press the button a fourth time to start the sanitisation function. The
icon will appear on the
display.