Operating Instructions and Installation Instructions

V 03/17
56
N.B.:
• Add an insulating tube to the indoor drain pipe to
prevent condensation.
• The plastic wall plugs are not supplied.
tubodiuscita outletpipe
tubodiscarico drainpipe
nastro tape
Step seven: connect the indoor unit electrical cable
1. Open the panel. Remove the screw that
secures the small panel covering the terminal
board.
coperchio cablaggio
vite
pannello
2. Insert the indoor and outdoor unit connecting
cable into the rear hole corresponding to the
terminal block. Then pull it out of the front.
cavo di
alimentazione
foro di
passaggio
cavo
pannello panel
vite screw
coperchiocablaggio wiringcover
forodipassaggio cable
cavo through‐hole
cavodialimentazione powercable
3. Remove the cable clip. Connect the power cable to the terminal block according to colour.
Tighten the screw and secure the power cable with the clip.
blu blue
nero black
marrone brown
giallo‐verde yellow‐green
Collegamentounitàesterna Outdoorunitconnection
4. Reposition the terminal block cover and tighten the screws.
5. Close the panel.
N.B.:
• All wiring must be connected as shown on the unit's wiring diagram.
All indoor and outdoor unit cables must be connected by a qualified technician.
• If the power cable is not long enough, contact the supplier for a new one. Do not attempt to
extend it yourself.
• For air conditioners equipped with a plug, the plug must be easily accessible upon completion
of installation.
• For air conditioners without a plug, install a circuit breaker on the line. The circuit breaker
must be single-pole and the contact gap must be greater than 3mm.
Step eight: bind the pipes
1. Bind together the connecting pipe, the power
cable and the drain pipe with binding tape.