Operating instructions

ManualsBrandsArgoclima ManualsDomestic AppliancesHi Floor Design Plus

V 05/11 6

OPERATING INSTRUCTIONS

Read the instructions carefully before operating the convector or carrying out maintenance operations.

Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or damages.

Store these instructions.

ELECTRIC CONVECTION HEATER

Summary of content (5 pages)

PAGE 1
EN ELECTRIC CONVECTION HEATER OPERATING INSTRUCTIONS Read the instructions carefully before operating the convector or carrying out maintenance operations. Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or damages. Store these instructions.
PAGE 2
GENERAL SAFETY INFORMATION  Use this convector only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons.  Ensure that the mains voltage complies with that indicated on the convector data plate (220-240VAC/50Hz).  Remove the convector from its packaging and check that it is in good condition before use. Keep any plastic bags away from children.
PAGE 3
WARNING: do not use the convector with an external controller or any other external device that activates the convector automatically, as there may be a risk of fire if the convector is covered or incorrectly positioned.  Upon initial start-up, the convector may emit a slight, harmless smell. This smell is a normal effect of the initial heating up of the internal heating elements, and should not recur later on.  Do not attempt to repair, disassemble or modify the convector.
PAGE 4
HOW TO ASSEMBLE THE FEET SUPPLIED The convector is packed without feet. These must therefore be assembled before using the appliance. To fix the feet supplied to the convector base, use the 4 screws provided with the unit, taking care to ensure that they are located correctly in the bottom ends of the heater side. HOW TO USE THE CONVECTOR Choose a suitable place to position the convector, considering the general safety warnings given in the first part of this manual.
PAGE 5
OPERATING TIMER (HI FLOOR DESIGN PLUS model) The model HI FAN DESIGN PLUS is also equipped with 24 hours timer, which has 96 segments, each of which corresponds to 15 minutes of time and allows the lighting and working programming of during the 24 hours. Red switch on - OFF: The convector doesn’t work or stop working. Red switch on - Timer ON: It allows you to program the convector on and off timing. Place the outer ring on the time you want the convector turn on: for example, to set the lighting at 8 p.m.