Jonio Professional Air purifier With UV lamp and photocatalytic filter
FEATURES INDEX ANION MODE: Safety precautions….………...…. 3 positive ions abound in air, they are emitted by several appliances, such as radio and television. In the mode Air purifier description…….………4 ANION several negative ions are emitted, they abound naturally in places where there are feelings of Control panel and remote control .5 well-being such as in the mountains. Air becomes fresh such as air in the montains. Maintenance of the appliance...….
SAFETY PRECAUTIONS Read carefully these instructions before using the appliance. Before operating the appliance check that the technical data declared on the plate conform to the voltage of the electrical supply network. Place the appliance on a flat and stable surface. Keep at least 60 cm distance from curtains, furniture, walls and other surfaces that could be an obstacle to the air flow. For a better circulation of the air, we suggest to keep the air puirfier at least at 50 cm from the floor.
DESCRIPTION OF THE AIR PURIFIER A. Control panel B. UV lamp – 3 pieces C. HEPA filter D. Prefilter E. Photocatalytic filter F. Prefilter cover G. Control panel (air flow entrance) H. Remote control I. Handle J. Air flow exit K. Supply cord 1.Pre-filter. Its main function is to filter the biggest particles and then as a consequence, the life of the HEPA filter can be longer. 2.HEPA filter. It can filter particulate with a diameter higher than 0.
CONTROL PANEL AND REMOTE CONTROL A. ON/OFF B. ANION (IONIZATION) C. PHOTOCATALYSIS D. STERILIZATION E. REVIVAL F. WIND G. TIMER H. UV LAMPS I. LIGHT FOR FILTER SUBSTITUTION – (MAINTENANCE) J. RESET The air purifier can be used both with the control panel and with the remote control. Switch on/off: Press button ON/OFF(A), the indicator will light. The appliance begins to work in PHOTOCATALYTIC mode purification at the intermediate speed and two UV lamps will be on.
While we are in mode sterilization, three indicators will light. If no indicator will light, you must check the UV lamps: they could be broken. You have to use the remote control towards the main unit and the receiver. Make sure that there are no objects in the path of the signal. In the moment during which the main unit receives the signal, a sound will be emitted. Avoid to damage the remote control. Do not expose it to the sunlight or near a heater.
Substitution of the HEPA filter (suggested every 6 months) Remove the front panel, remove the prefilter and extract the HEPA filter. Place a new HEPA filter and then the prefilter. Place at its place the front panel. Substitution of the UV lamps (medium life 5.000-8.
TROUBLESHOOTING PROBLEM CAUSE SOLUTION Air purifier does not - The plug does not fit correctly into the - Fit correctly the plug into the work socket socket - The plug or the socket are loose or - Check the plug and the broken socket - The front panel is not fixed - Check the front panel and substitute it Remote control does -The battery is not inserted/The battery is -Replace the battery exhausted not work -The remote control has not been aimed -Aim it correctly correctly towards the a
