Operation Manual

www.argonaudio.com 10
6340A
What not to do when connecting a Source input
to your Argon 6340A
Do not use a combined RCA and Mine-Jack (3,5mm) cable!
Often you will see a cable that has mini-jack at one end and
two RCA plugs at the other end. The cable will work but the
input sensitivity of mini-jack and RCA are quite different.
This will result in the Argon 6340A playing too low volume.
Basic Troubleshooting
If the LED does not light up, check...
that the AC power cord is firmly plugged into the rear panel
and wall outlet.
to make sure the speaker rear panel power switch is ON.
that the speaker is getting power from the wall outlet.
that the rear panel voltage match to the operating voltage.
the fuse in the AC IN on the rear panel. If the fuse needs to
be replaced it is extremely important to replace only with
same fuse type and value.
If no sound output, check...
that the speaker is turned on (blue LED illuminated)
to make sure the R speaker is connected correctly to the L.
that the volume on the speaker back panel is not all the
way down.
the volume level on your iPod or other audio source is not at
level 0.
that there is music playing on your iPod or other audio
source.
If bass output is low, check...
speaker wire polarity (verify that wires are going to same
terminals on both speakers)
that the speaker placement is not too close to a wall or
other obstruction.
that the bass ports on the rear panels are not blocked by a
rodent or jelly sandwich.
If no output from right speaker, check...
that the speaker wire is properly connected from the left to
right.
Check by removing the speaker wire from both terminals on
each speaker and reconnecting.
Power Management (Auto Stand-by)
According to the EC regulations implemented January 1
st
.
2013 Argon Audio6340A will automatically go into auto
standby if they are without a music signal for 20 minutes.
This rule is applied by the EC in order to save power
consumption.