Operation Manual

Connecting Your System
Step 1 - SPEAKER WIRE CONNECTION




1
Connect the RED (+) and BLACK (-) terminals from the left speaker to the
corresponding terminals on the right speaker using the included speaker wire.
Be sure to match the red-colored side of the speaker wire with the RED (+)
terminals and the black-colored side to the BLACK (-) terminals on each
speaker.
Note: As the Argon Speaker system is self-powered, do not connect the speaker
terminals to the speaker outputs of a stereo receiver.
Detailed procedure:
Remove the pre-cut insulation on the end of the speaker wire and twist
the exposed wire strands 2-3 times.
Use your thumb and finger to the unscrew the binding post connector
Insert each speaker wire into the holes on the side of binding postconnector.
Retighten the binding posts. The stripped wire portion should be secured
firmly in the connector.
Repeat the procedure to connect the other end of the speaker wire to the other
speaker. Be sure to match the wire color to the same terminal color on each
speaker. Also make sure that none of the speaker wire strands have come in
contact with an adjoining terminal.
6
1
2
STEREO INPUTSTEREO INPUT
AUDIO INAUDIO IN
OUT TO
RIGHT
OUT TO
RIGHT
5VDC CHARGE FOR iPOD5VDC CHARGE FOR iPOD
POWER ON/OFFPOWER ON/OFF
RR
LL
SUB OUTSUB OUT


2
Step 2 - POWE R CABLE CONNECTION
Verify that the voltage is corresponding with the voltage for your area.
Connect the power cord into the left speaker and the other end into the wall outlet.