Operation Manual

www.argonaudio.com
8
DAB2+
3. Using Your Argon DAB2+ radio
3.1 Quick start
3.1.1 Start up
1. Extend the Antenna
2. Plug the Power supply into an electric outlet and into the back of the Radio.
3. Press “power” (9) on
4. The Radio will start searching for DAB stations automatically. This may take a few minutes and
the progress will be shown in the display.
5. Once finished searching, the Radio will start playing the first found station.
3.1.2 Basic Operating
1. Stations can be chosen by turning the “Tuning/Select” (3) knob/button.
2. Once the prefer station is found press the “Tuning/Select” (3) knob/button and the chosen station
will start playing.
3. To store a station on one of the 1-6 preset buttons, press and hold the wished preset button for 3
sec., while playing the station that you want to store.
4. When stored, the display will show “Preset X saved”
5. To change between the Modes DAB, FM, AUX and Bluetooth (if your Radio has this function),
press the “Source” (6) button repeatedly until you reach the preferred Mode.
6. To tune stations in FM Mode press and hold the “Autotune” (2) button for 3 sec. and the Radio
will scan to the next available station. You can store FM stations like mentioned in point 3.