Operation Manual

www.argonaudio.com
9
DAB2+
3.2 DAB mode
1. If you are not in DAB mode, press the Source (6) button continuously, until it shows “DAB”. It will
start playing on the last played station.
The radio displays the correct time in DAB and FM mode, after a full scan has been preformed) in
DAB mode for the first time (normally done automatically at first time installation. Your radio
retrieves the time information from a DAB station.
2. While in DAB mode, press the Source (6) button, and the radio switches to FM mode.
3. While in FM mode, press the Source (6) button, and the radio switches to AUX IN mode.
4. You can switch the DAB/FM/AUX IN by pressing Source (6) button at any time.
3.2.1 Scanning stations in DAB mode
There are two ways to scan for stations:
• Automatic full scan (autotune (2))
• Manual scan
To do an automatic full scan:
1. Press and hold the Display (5) button for three seconds and <Full scan> will show in the display.
2. Press the Tuning/select (3) button/knob and automatic full scan will start.
This may take a few minutes, during which you will see the displays in the sequence below.
When there scan is finished the first found station, starts to play immediately.
3. To preview another station, turn the Tuning (3) knob until the name of another station appears.
4. Press the Tuning/select (3) button/knob to select and listen to the new station.
To do a manual scan
1. Press and hold the Display (5) button for three seconds until the text in the display changes.
2. Turn the Tuning/select (3) button/knob until the display shows <Manual Tune>.