Operation Manual

Wireless Internet & FM Radio
10
Steps for connecting your Argon iNet1 to your wireless network
Step 1 - Power up the Argon iNet1
Plug the cable from the mains adapter into the socket labelled 12-15V DC on the back of
the Argon iNet1.
CAUTION: Use only the mains adapter supplied with the radio. Connecting a power supply
with a different rating will cause permanent damage to the radio and may be hazardous.
The display on the fr
ont of the Argon iNet1 will light up and say:
After a few seconds, this will change to show:
Step 2 - Scan for a wireless network connection
When the display says <Scan for networks>, press the SELECT button.
(Note: if you make a mistake at any point, press the BACK button to go back to the previous
screen.)
Argon iNet 1
< Scan for networks >