Assembly Instructions
1
2
Fittings
Screw
Wall Plugs
Components & Fittings will vary according to the blind selected
IMPORTANT
Components
PVC Venetian Blind
Simple Assembly Instructions -
A
Blind x 1
B
Wand x 1
1. Read these instructions carefully and familiarise
yourself with the procedure before assembling the unit.
Keep these instructions for future use.
2. Check that you have all the component parts following
the list above and familiarise yourself with each part
before proceeding.
3. Take all the fittings out of the plastic bag
and separate them into their groups.
4. Ensure you have enough space to lay out
all the parts before assembly
5. To avoid scratching it is recommended that you
assemble the unit on a soft level surface.
6. Take care when operating the manual release with the
internal blind retracted since it may fall rapidly
.
WARNING!
Young children can be strangled by loops in pull-cords, chains
and tapes, and cords that operate the product.
To avoid strangulation and entanglement, keep
cords out of the reach of young children.
Cords may become wrapped around a child’s
neck.
Move beds, cots and furniture away from window
covering cords.
Do not tie cords together. Make sure cords do not
twist and create a loop.
*
*
*
*
Head rails of internal blinds with pull cords shall not be
installed less than 1.5m from the floor
.
*
G
Cord consolidator x 1
F
Hold Down
Bracket x 2
E
Cleat x 1
C
A safety device is fitted to the cords of this blind, it will open and release the cords if something becomes caught in the cord loops. To re-assemble after the
cords have been released, or after shortening the cords, re insert the cords into the device as below figure. Please ensure there is a knot on the end of each
individual cord before clipping the device back together.
Instruction to install safety device- cord consolidator breakaway device G
Please keep for future reference
192/2864 189/7645 191/6409 190/8369 187/4211191/4377
192/3643 191/7123 190/9825 190/8589 191/9475190/2918
191/8854 191/8524 191/8782 191/5352 189/6141
2 pull cords condition 3 pull cords condition
NOTE: A safety device is fitted to the cords of this blind,
it will open and release the cords if something becomes
caught in the cord loops.
To re-assemble after the cords have been released, or
after shortening the cords, re-insert the cords into the
device as illustrated fig.20.
Please ensure there is a knot on the end of each
individual cord before clipping the device back together.
fig. 20
2 pull cords condition
3 pull cords condition
Bracket x 2
H
Bracket Face
Plate x 2
D
Center Support
Qty
None
1
2
3
Blind Width
60cm
90-120cm
150cm
180cm
Blind Width
60cm
90-120cm
Qty
12
15
150cm 18
180cm 21
Blind Width
60cm
90-120cm
Qty
12
15
150cm 18
180cm 21