Assembly Instructions

ManualsBrandsArgos Home ManualsGarden furnitureSicily 6 Seater Metal Patio Set - Grey

Width - 140cm

Depth - 89cm

Height - 71cm

Assembly Instructions - Please keep for future reference 2926106

Dimensions

Sicily 6 Seater Patio Set

Issue 1 -28/07/14

Important - Read these instructions fully before starting assembly

If you need help or have damaged or missing parts, call the Customer Helpline: 03456400800

Summary of content (5 pages)

PAGE 1
Sicily 6 Seater Patio Set Assembly Instructions - Please keep for future reference 2926106 Dimensions Width - 140cm Depth - 89cm Height - 71cm Important - Read these instructions fully before starting assembly If you need help or have damaged or missing parts, call the Customer Helpline: 03456400800 Issue 1 -28/07/14
PAGE 2
Safety and Care Advice Important - Read these instructions fully before starting assembly • This product is manufactured from toughened safety glass. In the unlikely event that the glass fails it will break in to a large number of small fragments that may be spread over a wide area. This is a feature of toughened glass ,designed to remove the risk of Injury from glass breaking into large shards. • If the glass is chipped or broken , stop using the product and consult the manufacturer or supplier.
PAGE 3
Components - Parts Please check you have all the parts listed below 1 4 Table Top x 1 Leg x 4 2 Center Connector x 1 5 3 Support x 2 Center Connector With Ring x 1 Components - Fittings Please check you have all the fittings listed below Note: The quantities below are the correct amount to complete the assembly. 6 ST4.2 x 12 Screw x 6 D9 d6.5 x D13 x 1.0 Washer x 24 7 M6 x 55mm Bolt x 8 E10 M6 Metal Nut x 12 C8 M6 x 52mm Bolt x 4 F11 M6 x P1.
PAGE 4
Assembly Instructions Step 1 Place the table top 1 onto a non-abrasive surface, such as a carpet, with its underside facing upwards. Insert the legs 2 and the supports 3 into the plastic holders on the underside of the table top 1 rim. 2 2 2 2 3 3 1 Step 2 Attach the supports 3 and legs 2 to the plastic holders on the underside of the table top 1 rim by using screws 6 .
PAGE 5
Assembly Instructions Step 3 Attach the center connector 4 and the center connector with ring 5 to the middle of the legs 2 by using bolts 7 , washers 9 , Metal Nut 10 and palstic nuts 11 . Attach the center connector 4 and the center connector with ring 5 to the middle of the legs 3 by using bolts 8 , washers 9 , Metal Nut 10 and palstic nuts 11 . Make sure that all of the bolts have been tightened completely and cover them with bolt caps 12 .