User's Instructions

4 Customer Helpline 0345 640 3030
Installation
Installation
IMPORTANT ! - Electrical connections must be car-
ried out by a suitably qualified person and in accordance
with all relevant local building and installation regulations.
If in doubt consult a qualified electrician.
Installation
1. Insert the upper section into the head and secure using
the Allen key provided.
2. Screw the wired pole onto the bottom of the upper
section taking care not to twist or damage the cable.
3. Screw the non wired pole onto the bottom of the upper
section.
4. Place the assembled poles through the base cover and
base weight, with the lower sections in place pull the
excess cable through the base taking care not to twist
the cable.
5. Secure the lower sections to the base with the washers
and hex nuts using the spanner supplied.
6. Screw the adjuster arm into the Child light.
7. Remove the curved glass shield. Insert R7S 118mm
into top head lampholder (not supplied). Refit the
curved glass shield over top of bulb.
8. Remove one screw from the round glass shield from
the adjustable head and slide to one side to gain
access. Insert the G9 bulb (not suppled) into the lamp
holder. Move the round glass shield back into place
and re insert screw.
9. Connect the plug to a normal household socket and
using the rotary dimmer controls turn on the light to
test. The rotary controls are also used to dim the light
level for both lights.
REPLACEMENT LAMP
Maximum wattage – See
lamp holder
Light bulb shape - See lamp
holder
REPLACING THE BULBS
REPLACE THE BULB BY USING GENTLE PRESSURE WHEN INSERTING IT INTO THE
LAMP HOLDER, MAKING SURE THAT YOU DON’T HAVE DIRECT CONTACT WITH THE
BULB AS THIS WILL SHORTEN THE LIFE OF THE BULB, USE A LINT FREE CLOTH OR
SIMILAR
7
6
4
3 2
1
5
Upper section
Head
Wired pole
Base
APPROVED
11/04/2016
ISSUE 4
Q.C
7
8