Assembly Instructions

ManualsBrandsArgos Home ManualsClothes rails and canvas wardrobesAdjustable Chrome 2 Tier Clothes Rail - Grey

Please keep for future reference

875/5027

Grey And Chrome Tidy Rail With Two Rails

Width - 84 cm

Depth - 42 cm

Height - 99.5 / 166 cm

Dimensions

Important

- Please read these instructions fully before starting assembly

If you need help or have damaged or missing parts, call the

Customer Helpline: 08456 400800

Summary of content (8 pages)

PAGE 1
Grey And Chrome Tidy Rail With Two Rails Assembly Instructions - Please keep for future reference Dimensions Width - 84 cm Depth - 42 cm Height - 99.
PAGE 2
Safety and care advice Important - Please read these instructions fully before starting assembly • Check you have all the components and tools listed on pages 2 and 3. • Assemble on a soft level surface to avoid damaging the unit or your floor. • Parts of the assembly will be • Remove all fittings from the plastic bags and separate them into easier with 2 people. their groups. • If using power tools, please • Keep children and animals away follow the safety instructions supplied with the tools.
PAGE 3
Components - Parts Components Please check you have all the panels listed below A 1 x Hanger B 2 x Lower Side Support C 1 x Top Crossbar D 2 x Upper Side Support (Inserted inside component B) E 2 x Bottom Crossbar F 2 x Leg Section G 4 x Castor 2
PAGE 4
Components -Fittings If you have damaged or missing components, call the Customer Helpline: 08456 400800 Please check you have all the fittings listed below Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings may be supplied than are required.
PAGE 5
Assembly Instructions Stage 1 – Fitting the Feet NOTE: It would be useful to ask someone to help you at this stage. F 1. Insert Bottom Crossbar E into the Leg Section . F. See fig. 1. E F 2. Insert Lower Side Support B into the Feet. F . See fig. 2. fig. 1 B F F fig. 2 3. Insert Castors G into the Feet F . See fig. 3. G F F fig.
PAGE 6
Assembly Instructions Stage 12– – Fitting the Feet Fitting the Rail Stage NOTE: It would be useful to ask someone to help you at this stage. 1. Insert Top Crossbar C into the Connectors A . See fig. 4. C fig. 4 A A 2. Insert Upper Side Support D into the Connectors A . See fig. 5. A A fig.
PAGE 7
Assembly Instructions Stage 3 – Fitting the Hanger NOTE: It would be useful to ask someone to help you at this stage. A B B fig. 6 1. Insert Hanger A into the Lock B . See fig. 6. Unlocked 2. Insert Locks B into the Lower Side Support B . See fig. 7. fig. 8 D 3. Insert Locks B into the bottom of Upper Side Support D . Locked NOTES : Align all the holes of the componets B , D & B before locking. fig. 9 4. Set the height of the unit: Using the holes on Upper Side Support D .
PAGE 8
Assembly Instructions Stage 4 – Finishing the Unit NOTE: It would be useful to ask someone to help you at this stage. 1. Carefully place the unit in the desired location. See fig.11 And please hold Upper Side Support and pull downward. It’ll be fixed if locked or will be glided downward if unlocked. NOTE: Before use always make sure the unit is secure. fig.