Assembly Instructions

ManualsBrandsArgos Home ManualsClothes rails and canvas wardrobesAdjustable Chrome 2 Tier Clothes Rail - Grey

Grey and Chrome Tidy Rail with Two Rails

Dimensions

Width - 84cm

Depth - 42cm

Height - 99.5/166cm

Important - Please read these instructions fully before starting assembly

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Assembly Instructions - Please keep for future reference

875/5027

Issue 1 - 29/05/10

Summary of content (6 pages)

PAGE 1
Grey and Chrome Tidy Rail with Two Rails Assembly Instructions - Please keep for future reference 875/5027 Dimensions Width - 84cm Depth - 42cm Height - 99.
PAGE 2
Safety and Care Advice Important - Please read these instructions fully before starting assembly • Check you have all the components and tools listed on page 2. • Remove all fittings from the plastic bags and separate them into their groups. • Keep children and animals away from the work area, small parts are a choking hazard. • Make sure you have enough space to layout the parts before starting. • Assemble on a pad to avoid damaging the unit or your floor.
PAGE 3
Components - Panels If you have damaged or missing components, call the Customer Helpline: 08456 400800 Please check you have all the panels listed below 1 Hanger x 1 2 Lower side support x 2 3 Top crossbar x 1 4 Upper side support x 2 (Inserted inside component B) 5 Bottom crossbar x 2 Components - Fittings Please check you have all the fittings listed below Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings may be supplied than are required.
PAGE 4
Assembly Instructions Step 1 a: Fitting the Leg section B A Note: It would be useful to ask someone to help you at this stage. a: Insert Bottom crossbar 5 2 B into the Leg section A . 5 2 5 2 B A b: Insert Lower side support 2 into the Leg section B . b: B A B A 2 2 c: Insert Castors C A the Leg section .
PAGE 5
Assembly Instructions Step 2 Fitting the Rail a: Insert Top crossbar 3 into the Connectors A . a: b: Insert Upper side A 3 A b: support 4 into the Connectors A .
PAGE 6
Assembly Instructions Step 3 Fitting the Hanger a: Insert Hanger 1 into a: b: Insert Locks 1 D A D. the Locks A into the Lower side support 2 . D A D A b: 4 D into Insert Locks A the bottom of Upper side support 4 . 4 D A Note: Align all the holes of the Lower side support 2 , Upper side D support 4 & Locks A before locking.