Assembly Instructions

ManualsBrandsArgos Home ManualsClothes rails and canvas wardrobesDouble Adjustable Clothes Rail - Silver

Double Tidy Rail

Dimensions

Width - 89.5cm

Depth - 38.5cm

Height - 101/167.5cm

Important - Please read these instructions fully before starting assembly

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Assembly Instructions - Please keep for future reference

875/1698

Issue 1 - 01/06/10

Summary of content (6 pages)

PAGE 1
Double Tidy Rail Assembly Instructions - Please keep for future reference 875/1698 Dimensions Width - 89.5cm Depth - 38.5cm Height - 101/167.
PAGE 2
Safety and Care Advice Important - Please read these instructions fully before starting assembly • Check you have all the components and tools listed on page 2. • Remove all fittings from the plastic bags and separate them into their groups. • Keep children and animals away from the work area, small parts are a choking hazard. • Make sure you have enough space to layout the parts before starting. • Assemble on a pad to avoid damaging the unit or your floor.
PAGE 3
Components - Panels If you have damaged or missing components, call the Customer Helpline: 08456 400800 Please check you have all the panels listed below 1 Rail x 2 (89cm) 2 Bottom crossbar x 2 (83cm) 3 Lower side support x 4 (87cm) 4 Upper side support x 4 (78cm) (Inserted inside component 3) Components - Fittings Please check you have all the fittings listed below Note: The quantities below are the correct amount to complete the assembly.
PAGE 4
Assembly Instructions Step 1 a: D A Note: It would be useful to ask someone to help you at this stage. a: Insert Bottom crossbar 2 D. into Leg section A 2 2 D A b: Insert Lower side support section into Leg 3 2 D A b: .
PAGE 5
Assembly Instructions Step 2 Finishing the Unit a: Insert Rail 1 into Connectors A . a: 1 A A b: Insert Upper side A b: A supports 4 into Connectors A . Repeat steps a: and b: to assemble the other Rail 1 . c: Insert Castors C A 4 4 c: D .
PAGE 6
Assembly Instructions Step 3 Finishing the Unit B a: B 3 a: Insert Locks B onto 3 the top of Lower side support 3 . Align the Screw on Lock B into the hole on Lower side support 3 . b: Inert Upper side b: supports 4 into the Locks B . 4 B Note: It would be useful to ask someone to help you at this stage. c: C: Set the height of the unit Using the Upper side support 4 .