Assembly Instructions

ManualsBrandsArgos Home ManualsBar StoolsNitro Bar Stool - White

Nitro Bar Stool

Assembly Instructions - Please keep for future reference

Issue 1 - 18/04/16

Dimensions

Width - 44cm

Depth - 53.5cm

Height - 92.5-113.5cm

Important - Please read these instructions fully before starting assembly

If you need help or have damaged or missing parts, call the Customer Helpline:

Argos = 0345 640 0800

528/7316

523/8846

539/6324

hygena

Summary of content (5 pages)

PAGE 1
Nitro Bar Stool Assembly Instructions - Please keep for future reference hygena 528/7316 523/8846 539/6324 Dimensions Width - 44cm Depth - 53.5cm Height - 92.5-113.
PAGE 2
Safety and Care Advice Important - Please read these instructions fully before starting assembly • Check you have all the components and tools listed on the following pages. • During assembly do not stand or put weight on the product, this could cause damage. • Remove all fittings from the plastic bags and separate them into their groups. • Assemble the item as close to its final position (in the same room) as possible.
PAGE 3
Components - Parts If you have damaged or missing components, call the Customer Helpline: Argos = 0345 640 0800 Please check you have all the parts listed below 1 Seat 2 Upper leg 4 Decor ring 5 Base 3 Gaslift (32 x 27 x 39.5cm) (44 x 51 x 37cm) (Ø7.5 x 2.2cm) (Ø5 x 52-73cm) (Ø45 x 8.5cm) Components - Fittings Please check you have all the fittings listed below Note: The quantities below are the correct amount to complete the assembly.
PAGE 4
Assembly Instructions Step 1 Arrow Attaching upper leg Place the seat 1 upside down on a flat protected surface. Position the upper leg 2 and make sure that the arrow on the plate is pointing towards the front edge of the seat as shown in the inset diagram. Secure using washer B and bolt A . 1 Lever A B A B A A B B 1 3 Step 2 Attaching gaslift Plastic tip Place the base 5 on a flat protected surface.
PAGE 5
Assembly Instructions Step 3 Attaching the seat Position the seat as shown and insert the gaslift 3 into the upper leg 2 . Secure by pressing down the seat firmly. 2 3 Gaslift operation To adjust the seat higher, lift up the lever under the seat and release at desired height. To lower the seat, lift up the lever while seated on the stool. Lever Assembly is complete.