Aubrey - 4ft6 Bed Assembly Instructions- Please keep for future reference 549/6516 549/9441 709/6055 780/1116 829/7293 Dimensions Length - 200,5cm Width - 152,1cm Height - 110cm Important – Please read these instructions fully before starting assembly If you need help or have damaged or missing parts, call the customer Helpline: 03456 400 800 Issue 10 - 01/06/20
Safety and Care Advice Important – Please read these instructions fully before starting assembly . Check you have all the components and tools listed on pages 2 and 3. . Assemble on a soft level surface to avoid damaging the unit or your floor. . Remove all fittings from the plastic bags and separate them into their groups. . This product contain natural timber.
Components - Panels Please check you have all the panels listed below 01 Headboard (152,1 x 110,0cm) 04 Central Support (191 x 6cm) 02 Footboard (152,1 x 60,0cm) 05 Support Foot x 2 (27,8 x 6cm) 03 Side rails x 2 (190 x 11,5cm) 06 Slats x 26 (68 x 6,8cm) 2
If you have damaged or missing components, call theCustomer Helpline: 03456 400 800 Components- Fittings Please check you have all the fittings listed below Note:The quantities below are the correct amount to complete the assembly. In some cases more fittings may be supplied than are required.
Assembly Instructions Step1 D Fitting dowels Insert dowels D into the indicated parts. D 03 03 D D D Step 2 I mm 50 Assembling side rails A: Screw headless bolt I to footboard 02 as shown. Do not over tighten. A: 02 I Do not over tighten the bolts, see indicative measure. G B: Insert washer F to the side rails 03 and fit footboard to side rails. G H F Fix headless bolts I using nuts H and spanner G .
Assembly Instructions Step 3 Attach side rails 03 to the headboard. Insert half moon nut B into side rails 03 as shown. B B 01 Then fix them to the headboard 01 using bolts A and allen key C . B C 03 A B 03 C 02 A Step 4 Fixing support foot Fix Support foot 05 to Central support 04 using Bolt O and Allen Key C as shown.
Assembly Instructions Step 5 Fixing L shaped brack Fix L shaped brackets L into pre-drilled holes in the headboard 01 and footboard 02 using screws J as shown. Do not over tighten screws. L J J J J 01 02 Step 6 Fixing central supp Fix central support 04 to L shaped brackets in headboard 01 and footboard 02 using bolts M and nut H as shown.
Assembly Instructions Step 7 Using spacer N, centralize slats in bed frame prior to fixing. Fix slats using screws E , as shown. Fix slats in one side first, then fix them in the other side by pushing the rail against the slats if necessary. E N Fixing slats E E N N N 06 Periodically check that all screws are tight. Step 8 Additional step to fixing slats Make sure that s slats screws never collide to the screws on the slats support bar, as shown in the diagram.
8
