Assembly Instructions

ManualsBrandsArgos Home ManualsBar StoolsExecutive Gas Lift Bar Stool w/ Back Rest - Black

Executive Gas Lift Bar Stool

Assembly Instructions - Please keep for future reference 600/0372

Important

- Please read these instructions fully before starting assembly

If you need help or have damaged or missing parts, call the Customer Helpline:

Argos = 0345 640 0800

Issue 1 - 28/04/14

Dimensions

Width - 51cm

Depth - 51cm

Height - 87.5-107.5cm

600/1522

239/6011

Summary of content (5 pages)

PAGE 1
Executive Gas Lift Bar Stool Assembly Instructions - Please keep for future reference 600/0372 600/1522 239/6011 Dimensions Width - 51cm Depth - 51cm Height - 87.5-107.
PAGE 2
Safety and Care Advice Important - Please read these instructions fully before starting assembly • Check you have all the components and tools listed on the following pages. • During assembly do not stand or put weight on the product, this could cause damage. • Remove all fittings from the plastic bags and separate them into their groups. • Assemble the item as close to its final position (in the same room) as possible.
PAGE 3
Components - Parts If you have damaged or missing components, call the Customer Helpline: Argos = 0345 640 0800 Please check you have all the parts listed below 1 Seat 2 4 Decor ring 5 (51 x 44.5 x 36cm) (Ø7.5 x 2cm) 3 Upper leg (29.5 x 21.5 x 40.5cm) Gas lift (Ø5 x 46-67cm) Base (Ø50 x 9.3cm) Components - Fittings Please check you have all the fittings listed below Note: The quantities below are the correct amount to complete the assembly.
PAGE 4
Assembly Instructions Step 1 A Attaching upper leg Place the seat 1 upside down on a raised, flat and protected surface. B Position the upper leg 2 and make sure that the lever is at your right hand side as shown in the diagram. Secure using bolts A and tighten bolts using allen key B . 1 2 A B A B A B A Lever B 1 Step 2 Attaching gas lift Plastic tip Place the base 5 on a flat protected surface.
PAGE 5
Assembly Instructions Step 3 Attaching the seat Position the seat as shown and insert the gas lift 3 into the upper leg 2 . Secure by pressing down the seat firmly. 2 3 Step 4 Gaslift operation To adjust the seat higher, lift up the lever under the seat and release at desired height. To lower the seat, lift up the lever while seated on the stool. Lever Assembly is complete.