AVR Two Drawer Filer Assembly Instructions Please keep for future reference 617/3450 617/3467 N NN Dimensions Width 40cm Depth 48cm Height 76cm Important Please read these instructions fully before starting assembly If you need help or have damaged or missing parks, call the Customer Helpline: 08456 400800 Issue
/\ Safety and Care Advice Important Please read these instructions fully before starting assembly * Check you have all the components and tools listed on page 2 and 3. * Remove all fittings from the plastic bags and separate them into their groups. « Keep children and animals away from the work area, small parts could choke if swallowed. « Make sure you have enough space fo layout the parts before starting.
Components Panels [1] Right side 74 x 45cm) lzl Top (40 x 48cm) Bottom (36.7 x 44.8cm) |T| Drawer front x 2 IZl Left side (74 x 45cm) [3] Back (706 x37.8cm) (394 x35.1cm) Drawer bottom x 2 (34.5 x 32.8cm) 3 q El Drawer back x 2 (34.6 x 27cm) o o Drawer right side x 2 (33.5x 14cm) o o El Drawer left side x 2 (33.5x 14cm) Izl Back support (36.
Components Fittings soonest Please check you have all the fittings listed below Note: The quantities below are the correct amount to complete the assembly.In some cases more fittings may be supplied than are required.
Assembly Instructions 1 16 16 Fitting the track a: Use screws Qo fix the left side track Loon the left side panel[2 | NOTE: Ensure the screws (Are located using the center of the three locating holes. The front part of the track should ba close to the edge of the panel. b: Side the tracks to other side,then use screws o fix the tracks.
Step 2 -continued b: side back panel[ 3] into the unit Fitting the top panel a: Screw coking pins@® onto the top panel[4], Insert locking pins as far as shown. b: Carefully locate the top pane![ 4 onto the unit Continued on next page.
Step 3 -continued ©: Insert looking nuts © into right side panel[1] and left side paneling, then use a screwdriver C: to turn locking nuts @ clockwise fo lock. Use plastic plugs (3to cover the screws.
Step 4 -continued ©: Screw locking pins @ into drawer front panel[ 5] C: Insert locking pins as far as shown d: Carefully locate the d: drawer front onto the unit. ©: Insert lacking nuts@© e: into drawer right side parkland drawer left side panel[11], then use a screwdriver to tum looking nuts @ clockwise fo lock. Continued on next page.
Step 4 -continued f: Use handle screws © 1o fix the handle (@ onto f: the drawer front pane[5 | Use the same method as ina -f fix the other drawer. g: Use screws o fix . the drawers onto the g tracks. Finishing the unit Carefully place the unit in the desired location. Assembly is complete.
