Specifications
Please ensure the correct wall plugs are used
Installation & Assembly
1. Carefully remove packaging.
2.
Hold pole up to the window and centralise over
width to determine correct position and length.
The ideal position for the brackets is 10cm (4”)
above the window and 10cm (4”) out from the
edge of the window (fig.1). Remember to allow
sufficient length either side to accommodate the
curtains when opened.
3. Mark bracket positions on the wall, use a spirit
level to ensure brackets will be level. Hold pole
up against the marks to double check positions
before drilling.
4. Position the brackets on the wall and mark the
two holes on the wall and drill the holes
5. Using the wall plugs and screws provided fix
the brackets securely (Fig. 2). Alternative wall
fixings should be used where necessary.
Fig. 2
6. Drop the pole onto the brackets and centralise
over the window (Fig 3.) Adjust the length of
the pole as required.
7.
Remember to
position a ring between the
brackets and the finial (Fig. 4).
8. Reposition the pole and tighten the locking
screws on the brackets.
9.
The pole is now ready to accept curtains slipping
by slipping hooks through the eyelets on
remove any fingerprints. To maintain the
smooth performance of your pole periodically
wipe the pole with furniture polish.
Please note that specifications of fittings
may vary from those illustrated.
Retain for future reference.
Periodically check and re-tighten fixings
Tools Required:
Steel Tape Measure
Soft Pencil
Posi-Drive Screw Driver
Spirit level
Drill & Drill Bits
Hacksaw and file
Length metres
Contents 110cm to 200cm
mm Metal Curtain Pole
A
C
C
D
B
B
Assembly
to suit your wall type.
there are no
wall use
A Pole
2
B Brackets
3
C Finials
2
D Rings
20
E Screw Pack
1
Wall fixing kit supplied
for solids walls only.
When drilling into walls
check that
hidden electrical wires
or water pipes. If a non-solid
appropriate
wall fixings.
If in doubt seek
Please refer to the guide on the reverse
of these instruction.
professional
advice.
10.
After assembly wipe the pole with a dry cloth to
the rings.
13/16