Assembly Instructions

ManualsBrandsArgos Home ManualsBathroom AccessoriesToilet Brush & Toilet Roll Holder - Chrome Plated

Simple Assembly Instructions - Please keep for future reference

IMPORTANT

1. Read these instructions carefully and

familiarise yourself with the procedure

before assembling the unit.

2. Check that you have all the component

parts following the list on the back

cover and familiarise yourself with

each part before proceeding.

3. Take all the fittings out of the plastic bag

and separate them into their groups.

4. Ensure you have enough space to lay out

all the parts before assembly.

Half Moon Brush / Roll Holder

Components

5. To avoid scratching it is recommended

that you assemble the unit on a soft

level surface.

Fittings

1 x Tool

1 x Base

1 x Bottom Plate

1 x Roll Cover

1 x Tool

2 x Ring

1 x Tube Holder

1 x Angled Tube

1 x Tube

1 x Roll Holder

1 x Cover Holder

1 x Bracket

2 x

1 x

2 x Screw

4-03

1 x Brush Support

1 x Screw

Plastic

Plug

1 x Brush Handle

1 x Tube

Brush

Head

Rubber

Ring

Tube

Cover

2 x Long Screw

2 x Washer

4 x Washer

Summary of content (3 pages)

PAGE 1
Components Half Moon Brush / Roll Holder A 1 x Bottom Plate B 1 x Base Simple Assembly Instructions - Please keep for future reference C 1 x Tube Holder F 1 x Roll Cover D 1 x Angled Tube E 1 x Tube G 1 x Roll Holder H 1 x Cover Holder J 2 x Plastic Plug I 1 x Bracket L 1 x Brush Support K 1 x Brush Handle P 1 x Brush Head M 1 x Tube N 1 x Tube Cover O 1 x Rubber Ring IMPORTANT Fittings 1.
PAGE 2
Assembly Instructions Assembly Instructions Stage 1 – Fitting the Tube Stage 2 – Fitting the Base E A 1. Insert Angled Tube D and Tube E into the Bracket I . See fig. 1. 1. Use the Screws C and Washers B to fix Base B into the Bottom Plate A . See fig. 5. D NOTE: There is a hole close to the top of Tube E . Ensure you assemble this way up. fig. 5 B F fig. 1 fig. 2 B 2. Use Screws F to fix the Bracket I into the Tubes. See fig. 2. C I J 3. Insert Tube Holder C onto the unit.
PAGE 3
Assembly Instructions Assembly Instructions Stage 3 – Fitting the Paper Holder Stage 4 – Fitting the Brush H fig. 9 fig. 7 1. Use Roll Holder G to fix the Roll Cover F onto the Cover Holder H . Then use Screw D to fix the Roll Holder. See fig. 7. G D F 1. Screw the Brush Support L into the Brush Handle K and fix the Tube Cover N . Then screw into the Brush Head P . Ensure its a tight fit. See fig. 9. K N 2. Then place the assembled brush into the unit. See fig. 10. H 2.