Instruction Manual

Issue 1 25/2/2019
4
Securing the light fitting to the wall
1. Isolate the lighting circuit to be used and remove the circuit fuse or
switch off the circuit breaker at the consumer unit (fig.1).
2. Remove any existing light fitting from the wall.
3. Unscrew the domed nuts and separate the back plate from the light
fitting. Gently pull the terminal block to separate from the back plate
(fig. 2).
4. Position the back plate in the desired location and check with a spirit
level that the straight sides are vertical. Using the back plate as a
guide, mark the positions of the holes for the fixing screws and supply
cable (fig. 3). Check that there are no buried cables and pipes at
these positions.
5. If fixing to a masonry wall, use a 6 mm masonry drill bit and drill fixing
holes to a depth of 32 mm and insert the wall plugs into the holes.
Fig. 2
Fig. 1
Fig. 3