Instruction Manual

Issue 1 25/2/2019
7
 Any existing mounting plate or rose must be removed before installing
this fitting. When installing, a ‘loop in’ wiring system may be
encountered. If these are encountered, the wires from the existing
rose or loop must be transferred to the terminal block as per the
diagram below. It is recommended that a qualified electrician carries
this out, only attempt to connect the fitting if electrically competent.
Notes
 This product must be earthed – if no earth wire is available, consult an
electrician.
 All existing earth cables must be connected to the earth terminal to
ensure earth continuity throughout your property.