User manual

TV Connection
17
Power Connection
1. Connect the DC jack of the AC adapter to the connector marked “DC IN”, plug the other
end into an electrical outlet.
2. Press the Power switch to turn on this device, and then press the
STANDBY button
on the remote control to activate it. The activation takes about 5-7 seconds, and the LED
will blink at the same time.
3. After playback, press the
STANDBY button again to return to Standby mode.
4. If you want to move this device, turn off this device by pressing the Power switch until the
blue LED is flashing. Release the switch, and then it will be safe to remove all connections
after the LED turned off.
• When using the remote control, point the remote control towards the remote
receiver.
• During the remote control operation, the inhibit icon will appear on the
screen when a button of non-available operation is pressed.
• If the setting of the video output is incorrect, the TV screen will not display
normally. Switch to correct setting by pressing the TV SYS button to switch
output TV system. (See page 29 for more detail).
Mounting the USB External Storage
Compatibility
1. This device supports FAT16/32, NTFS and HFS+ file systems.
2. This device supports USB external HDDs and USB Flash drives.
3. This device does not supports USB Flash drives smaller than 512MB in capacity.
4. This device does not support file system with Allocation Unit Size smaller than 4096 bytes.
4096 bytes or larger Allocation Unit Size is required.
5. This device does not support USB Hubs
6. USB card reader support is not guaranteed.
7. This device does not support USB external CD/DVD/BD/HDDVD/other ODD drives.
Mounting of a USB External Storage