User manual

TV Connection
9
2. Press the Power Switch on the rear panel, or press the STANDBY button on the
remote control to activate this device. The activation takes about 5-7 seconds, and the
LED will blink at the same time.
3. After the LED stops blinking and glows steadily bright, this device is ready to use for
playback.
4. After playback, press the
STANDBY button again to return to Standby mode.
Note:
• When using the remote control, point the remote control towards the front
of this device.
When turning the HDD into Standby mode, please avoid moving it for 2-3 minutes due
to spin down of the device. Moving the HDD while it is still spinning may damage it. We
are not liable for any data loss or damage caused by inappropriate or careless use.
It is recommended to unplug the unit from the power socket completely when not in
use.