User manual

TV Connection

Component Video Connection (Y/Pb/Pr)

If your TV supports Component Video input (Y/Pb/Pr), you can connect it for better video

quality. You will have to connect the audio cable for audio output. You can also configure

display ratio, progressive scan, and the 1080I/720P up-scaling output in SETUP MENU >

VIDEO SETUP.

Note:

Some TV sets are equipped with separate composite and component audio

inputs. Be sure that you have connected the correct one.

SCART Video Connection

If your TV is equipped with SCART input, connect the Composite connectors to a SCART

adapter to output the audio/video signal. (SCART adapter not provided)

Coaxial Audio Connection

For a high quality digital audio, you connect this connector to an AV receiver which equips a

digital audio decoder. (Coaxial cable not provided)

Power Connection

1. Connect the DC jack of the AC adapter to the connector marked “DC IN”, plug the other

end into an electrical outlet.

2. Press the

STANDBY button on the remote to activate this device for playback.

3. After playback, press the

STANDBY button again to return to Standby mode.

• When using the remote control, point the remote control towards the remote

receiver.

• During the remote control operation, the inhibit icon will appear on the

screen when a button of non-available operation is pressed.

• If the setting of the video output is incorrect, the TV screen will not display

normally. Switch to correct setting by pressing the TV SYS button to switch

Green Red

Blue White

Red