User`s manual

Note: The FEED button does not make the printer cut. For

cutting to occur when the panel setting is properly

enabled.

Cutter

Configuration

This section discusses calibration, printing configuration and

resetting the printer to factory defaults.

Performing Calibration

After the media is loaded, recommend you performing media

calibration to calibrate the label sensor.

1. Turn off the printer

2. Press and hold the PAUSE button and turn on the power.

3. When “CALIBRATION …” is displayed on the LCD (X-2000v,

X-3000v), and both READY and MEDIA indicators blink,

release the PAUSE button.

4. The printer feeds 12-inches of blank labels.

5. When “READY” is displayed, the READY and MEDIA

indicators stop blinking but remain illuminated.

Note: For X-1000v, the step3 will be bypassed.

Important! Recommend you performing media calibration after

changing media. Failure to do so could result in

improper detection by the label sensor.