User`s manual

31
Printing a Configuration Report
To perform a self-test and print a configuration report:
1. Turn off the printer.
2. Press and hold the FEED button while turning on the power.
3. When “SELF-TESTING …” is displayed on the LCD
(X-2000v, X-3000v) and the READY indicator blinks,
release the FEED button.
4. The printer prints out a configuration report.
5. When “READY” is displayed on the LCD (X-2000v,X-3000v),
the READY indicator stops blinking but remains illuminated.
6. The following information is printed in the report:
• Font list
• Hardware configuration and status
• Label parameters
• Firmware version
Notes:
1. For X-1000v, the step3 and step5 will be bypassed.
2. After the self-test the printer enters the diagnosis mode
(Dump mode). To continue to normal operation, press
CANCEL button to cancel the diagnosis mod (Dump mode).
32
Resetting to Factory Default Settings
To reset the printer to factory default settings:
1. Turn off the printer.
2. Press and hold the CANCEL button and turn on the printer.
3. When “E2PROM RESET …” is displayed on the LCD
(X-2000v, X-3000v) and the READY indicator blinks,
release the CANCEL button.
4. When “READY” is displayed on the LCD(X-2000v, X-3000v),
the READY indicator stops blinking but remains illuminated.
5. When the two indicators relight, release the feed button.
6. The following information is printed in the report:
• Label parameters
• Heat (Darkness)
• Speed
• Symbol set (language)
• Others for specific emulation
Notes:
1. For X-1000v, the step3 and step4 will be bypassed.
2. All settings stored in FLASH memory are retained even after
turning off the printer.
3. You must perform the calibration for label sensitivity after
you reset.
4. Printed label count is not reset.