User`s manual

Placing the Printer

Before setting up and connecting the printer you should consider

the following.

WARNING! Do not operate the printer in an area where it might

get wet.

• Find a solid flat surface with adequate room for the printer

and enough space above for media and ribbon access.

• Place the printer within cable distance of the host and

printer (serial or parallel cable.)

• Isolate the power cord from other electrical cables.

Connecting the Power Cord

Connect the power cord as below.

WARNING! For the X-1000v, make sure the power slide switch on

the rear panel is switched to the correct local voltage,

either 115V or 230V (default), otherwise damage to

the printer may occur.

1. Make sure the power switch is in the "O" position.

2. Plug one end of the power cord into the power jack on the back

of the printer, and the other end of the cord into an AC electrical

outlet.