User`s manual

87
7. Thread the cutter cable through hole (8) and route it to the
JP16 connector (CUTTER) on the main board.
8. Turn on the printer.
9. For the X-2000v/X-3000v models set the parameter of
“CUTTER INSTALLED” on the LCD to the ON position. For
the X-1000v model bypass this step.
After the cutter is installed, install media and ribbon.
1. Put the media end on the roller.
2. Close the TPH latch.
3. Hold the PAUSE button and turn on the printer.
4. Release the button when the cutter starts cutting.
5. After cutting, the printer will feed the label for 8 inches.
Note: The procedure above is for first time installation or after
cutter jam. Normally the procedure for loading the media
through the cutter is:
1. Put the media end on the roller.
2. Close the TPH latch.
3. Turn on the printer.
4. Press the FEED button to feed the media end through
the cutter.
88
Appendix D: Dispenser Installation
Install a dispenser into the printer as follows:
1. Turn off the printer.
2. Remove the top cover on the right side.
3. Insert the left side of dispenser bracket and secure the three
screws to the TPH module.