User`s manual

7
Buttons
There are three buttons, each with two basic functions.
Button Function 1
(Press the button)
Function 2
(Press the button and
power switch together)
FEED Feed a label Perform self test & print
configuration report
PAUSE
• Pause printing
• Press again to resume
printing
Perform a media
calibration
CANCEL
• Interrupt and delete a
print
task
• Force printer to continue
after an error is solved.
Reset FLASH settings
Notes:
1. You should perform a media calibration after installation and
when changing to a different type or size of media.
2. Before calibration, you must load the media and ribbon
properly and move the label sensor to the correct position.
3. After calibration the printer saves parameters to FLASH.
Without correct calibration gap detection is easily lost during
printing especially for small labels (less than 1.5 inches in
height).
4. After self-test, the printer is in dump mode. For normal
operation, you must press CANCEL to restart the printer.
8
LCD Display (X-2000v / X-3000v models)
The X-2000v and X-3000v models have an LCD that shows:
• printer status
• printer settings
• input data from a keyboard or barcode reader
After power-on, the LCD displays the following message:
The first parameter is either 203 or 300, which stands for the printer
resolution. The second parameter indicates the emulation (printer
language), PPLA, PPLB or PPLZ.
If a keyboard is plugged in, the display shows:
If a barcode reader is connected, the display shows:
If an abnormal condition occurs, a related message is displayed.
For example:
READY (203,PPLB)
READY (203,PPLB)
<ESC> FOR KEYBD
READY (203,PPLB)
WITH B.C. READER
RIBBON OUT