User's Manual

Wireless 802.11a CPE

User Manual

Page 3 of 36

1. G

ETTING

TARTED

The WLAN Broadband CPE is delivered

with the following factory default parameters on the Ethernet LAN

interfaces.

Default IP Address: 10.10.10.254

Default IP subnet mask: 255.255.255.0

WEB login User Name: admin

WEB login Password: admin

The device has four operation modes (Bridge /Gateway/WISP /AP Client). The default IP addresses for the

device are 10.10.10.254, so you need to make sure the IP address of your PC is in the same subnet as the

device, such as 10.10.10.X.

It will take about 25 seconds to complete the boot up sequence after power on.

Prepare your PC to configure the WLAN Broadband CPE

For OS of Microsoft Windows 95/ 98/ Me:

1. Click the Start button and select Settings, then click Control Panel. The Control Panel

window will appear.

Note: Windows Me users may not see the Network control panel. If so, select View all

Control Panel options on the left side of the window.

2. Move mouse and double-click the right button on Network icon. The Network window will

appear.

3. Check the installed list of Network Components. If TCP/IP is not installed, click the Add

button to install it; otherwise go to step 6.

4. Select Protocol in the Network Component Type dialog box and click Add button

5. Select TCP/IP in Microsoft of Select Network Protocol dialog box then click OK button

to install the TCP/IP protocol, it may need the Microsoft Windows CD to complete the

installation. Close and go back to Network dialog box after the TCP/IP installation.

6. Select TCP/IP and click the properties button on the Network dialog box.

7. Select Specify an IP address and type in values as following example.

 IP Address: 10.10.10.1, (any IP address within 10.10.10.1 to 10.10.10.253 is good

to connect the Wireless LAN Access Point).

 IP Subnet Mask: 255.255.255.0

8. Click OK and reboot your PC after completes the IP parameters setting

For OS of Microsoft Windows 2000, XP:

1. Click the Start button and select Settings, then click Control Panel. The Control Panel

window will appear.

2. Move mouse and double-click the right button on Network and Dial-up Connections

icon. Move mouse and double-click the Local Area Connection icon. The Local Area

Connection window will appear. Click Properties button in the Local Area Connection

window

3. Check the installed list of Network Components. If TCP/IP is not installed, click the Add

button to install it; otherwise go to step 6.

4. Select Protocol in the Network Component Type dialog box and click Add button.