Operation Manual

ARGUS
A
RGUS 125 111
Level measurement - other TE
In TE mode, the ARGUS will measure the level of a terminal connected in parallel. In this
case, the ARGUS is passive. Layer 1 must be activated on the terminal. The ARGUS
updates its measurement continuously.
The ARGUS in its Main menu
Start measurement
The ARGUS displays the level of the useful signal and
an evaluation of this level:
<< Level is too low
>> Level is too high
OK
Level is in order (0.75V
+20%
-33%
, i.e.
from 0.9V to 0.5V)
none no level
< R>ON > 100Ω resistor switched in
<R>OFF > 100Ω resistor switched out
<NEW> to set up Layer 1 again - to ensure a
reasonable measurement.