Operation Manual

ARGUS
A
RGUS 125 121
Alerting mode You can specify whether, for an incoming call on a BRI point- to-
point access, the ARGUS should only display the access number
without extension or the complete number with extension.
If it is set to “Manual”, the ARGUS will display the extension (An
incoming call will be signaled. The ARGUS will send the Layer 3
message “Alert” when it accepts the call. The digits of the
extension that have been sent by this point will be displayed.).
With the Manual setting, an incoming call must be
answered within 20 seconds or it will be lost. Furthermore,
you should note that the remote subscriber will not hear a
ringing tone.
If it is set to “Automatically”, the ARGUS will only display
the access number without extension or, depending on the
configuration of the access in the exchange, it may not
display the number called at all.
Clock mode This parameter sets where the clock will be generated in the case
of a BRI or PRI access. You can either specify that the ARGUS
generates the clock (is Master) or that it is the slave of a clock
generated at the other end (Slave).
Default setting:
NT mode
TE mode
Permanent switch
circuit (leased
line)
Master
Slave
Slave
This setting will not be saved permanently, rather only applies for
the current measurement.
BRI
termination
Independent of the operation mode (TE or NT), a terminating
resistor can be switched-in on the BRI access.
Default setting:
NT mode
TE mode
Leased line
Terminating resistor switched-in
No terminating resistor is switched in
No terminating resistor is switched in
This setting will not be saved permanently, rather only applies for
the current measurement.