Operation Manual

ARGUS
A
RGUS 125 123
Sa6 coding
0000
1010
1111
Meaning
Network -> Terminal
Setting for normal
operation (default)
Switches a loop in the
NTPM.
In leased line mode, a
BERT can then be
performed using the loop
setup there.
Important: The ARGUS
must be set to “Leased
line” even if it is a dialup
access!
Switches a loop in the
LEPM.
In leased line mode, a
BERT can then be
performed using the loop
setup there. Important: The
ARGUS must be set to
“Leased line” even if it is a
dialup access!
Meaning
Terminal -> Network
Setting for normal
operation, idle (default)
-----------------------
AIS on U
2an
of the NTPM
A bit Using the ARGUS, you can set the A bit on a PRI access.
By default, it is preset to A=0 (automatic).
This setting will not be saved permanently
CRC4 mode CRC4 monitoring can be switched on or off manually.
By default, it is preset to CRC4.
This setting will not be saved permanently