Operation Manual

ARGUS
124
A
RGUS 125
Call parameter Two different parameters can be set for (ISDN) calls generated on
both the network-side (ARGUS in NT mode) and on the user-side
(ARGUS in TE mode):
1. Type of number (TON) for the CGN (=CGPN) or CDN (=CDPN)
element of a SETUP signal:
Network-side: Net CGN TON /
Net CDN TON
User-side: User CGN TON /
User CDN TON
2. Numbering Plan (NP) for the CGN (=CGPN) or CDN (=CDPN)
element of a SETUP signal
Network-side: Net-CGN-NP/
Net-CDN-NP
User-side: User CGN NP /
User-CDN-NP
Possible settings:
For TON: unknown, international, national, network spec.,
subscriber, abbreviated.
For NP: unknown, ISDN/telephony, data, telex, national stand.,
private
Services Up to three user-specific services (user spec.1 to user spec.3) can
entered and saved.
For each "user spec. service“, you must enter the info-elements
BCAP, HLC and LLC in hexadecimal (switch with the left softkey).
To do so, use the keypad and the < A . . F < softkey (e.g. to enter a
"C", press the softkey three times; for a "F", press it six times).
Call
Acceptance
If the ARGUS is set to “own MSN/DDI“ and is in TE mode on a P-
MP access, it will only signal those calls which are placed to the
MSN (on a P-P access, the DDI) of the access under test.
If set to "all MSN/DDI“, the ARGUS signals all calls.
Prerequisite:
- the “own” number must be entered in the call number memory
under “own number” (see “Saving Call Numbers” on page 133.)
- the incoming call must have a destination MSN
The default setting is “all MSN/DDI”.
This setting will be saved permanently.