Operation Manual

ARGUS
72
A
RGUS 125
ARGUS in the Single tests menu
Enter the number of the access under test
There are PBXs that use separate call numbers for
incoming and outgoing calls.
In this case, for the Service tests, you can enter a “remote” call number that does
not match the “own” number that is stored in the ARGUS.
If the Service test should extend outside of the local exchange, it is possible to perform the
Service test in an end-to-end mode.
In this case, you must enter the remote call number for a second terminal device. The
ARGUS will then automatically check whether the remote terminal can accept the call
under the various services – in other words, whether it is “compatible” with these services.
In the test results, the second part (second +, - or *) refers to the answer from the remote
exchange.
The ARGUS will display the results of the test once it
is done.
Use the cursor keys to scroll through the results.
The ARGUS makes a distinction between outgoing
calls (the first +, - or *) and incoming calls (the second
+, - or *).
+ =
- =
*
Service supported
Service not supported
A definite statement cannot be given, see the
adjacent error code for the reason.
to scroll through the results.
Close the results display.
The ARGUS will return to the
previous display.
Enter own number
Service test starts
Test results: