Operation Manual

ARGUS
A
RGUS 125 75
In the Single tests menu, select the X.31 test.
Use the cursor keys to select Automatic.
Use the cursor keys to select D-channel.
Start the test
The test can take up to 4 minutes (a rotating bar will be
displayed). The ARGUS will display the currently
tested TEI, the previously tested TEI and the results:
After the test is completed, the ARGUS will show
whether the X.31 service is available for Layer 3 for
the TEIs found in Step 1.
Use the cursor keys to scroll through the results.
Test results:
If the X.31 service is not supported, the ARGUS will
report “X.31 (D) n. impl.”.
OK
NOK
= X.31 is available for this TEI
= X.31 is not available for this TEI
TEI:02
Layer 2:
Layer 3:
+
-
+
-
The first valid TEI value is 02.
test step was successful
1. test step was unsuccessful
2. test step was successful
2. test step was unsuccessful.
In this case, the ARGUS will display
the relevant X.31 cause for the failure
(in the example above, 13) and the
associated diagnostic code (in the
example, 67) if available (see page
145).