Operation Manual

ARGUS
92
A
RGUS 125
11.4 Incoming Call
An incoming call can be taken at any time even when a test (e.g. BERT) is in process (see
page 97).
The ARGUS will signal an incoming call with an audible tone and a message on the display.
On a P-MP access, you can use the Call acceptance (see “Call Acceptance” on page
124.) function to configure the ARGUS to only signal incoming calls which are addressed
to the MSN that corresponds to your own call number. This function can only be used when
your own call number has been entered into the ARGUS’s speed-dialing memory (see
page 133) and the incoming call has a destination MSN.
The ARGUS displays the service (Tel.), the number of
the caller (02351907070), the B-channel used (B01)
and the number called (90700).
The ARGUS will display the complete destination
number (DDI), if the Alerting mode is set to manual
(see page 121).
Use the cursor keys. View additional information (if
available).
To take the call.
Press the the cursor keys to view more information.
The ARGUS displays the cause of the disconnect (see
page 93).
Charge information in NT mode:
In NT mode, the ARGUS will – for incoming calls – send advice of charges in accordance
with DSS1 as units and as currency (in Euro).
<TM> Start the Test Manager (see page 96)
or
Clear the connection
Reject call