Datasheet

9 VoIP test
106 ARGUS 141
Registrar 
server
Use Registrar. Setting: yes or no: If an Internet Telephony
Service Provider (ITSP) is used (in such case, you will
dial a normal telephone number), a regis-trar must be
used. A registrar is not needed if you dial a VoIP phone
directly, e.g. via its IP address or SIP-URI.
Default setting: No
Registrar Server
Address of the registrar server
Outbound
proxy / SBC
(SBC = Session Border Controller)
Use proxy: This setting specifies whether or not to use
Outbound Proxy.
Default setting: No
Outbound Proxy / SBC
Address of the outbound proxy server
Outbound proxy/SBC Port
Port of the outbound proxy serverRange: 0 to 65535
Default: 5060
SIP domain Configuration of the domain name for the “From” field in
the SIP message (when using an Internet Telephony
Service Provider (ITSP)).
Listen port The port used for the incoming SIP signaling
Range: 0 to 65535
Default: 5060
Remote port The port used by the remote end. When using a registrar
(see Registrar Server Setting on page 105), enter the
port number of the Registrar / Proxy Server; otherwise,
enter the port number of the remote end.
Range: 0 to 65535
Default: 5060
Authentication Addtional xTU-R password used for proper
authentication with the registrar.
For information on the softkeys, see page 105
Caller ID Optional entry of any text desired which will then be
displayed on the called party's equipment instead of the
caller's phone number.
For information on the softkeys, see page 105