Datasheet

11 ARGUS Settings - Device
ARGUS 141 125
Ringer
volume
With this setting you can set the volume level used by the ARGUS to
signal an incoming call.
The initial volume level can be set.
- Default setting: Level 1 (very low)
In addition, you can also set the final volume level.
- Default setting: Level 7 (very loud)
When an incoming call is received, the ARGUS will begin signalling
with the initial (very low) volume and increase the volume by one
increment each time it signals until it has reached the final (very
loud) volume.
Alarm bell The ARGUS signals with an audible alarm in a variety of situations,
e.g. when a bit error occurs in a BERT or the ARGUS has
synchronized on an xDSL or when an error counter increments. 
When this parameter is set to "off“, all audible alarms are
suppressed.
Default setting: Off
Power
management
- Automatic turn off
Set the how long the ARGUS can remain idle before it will
switch to power down mode if it is not connected to the plug-in
power supply. If power down mode is disabled, when the
ARGUS is switched on, it will display a message warning that
this will lead to a shorter battery life.
Default setting: after 5 minutes
- Lighting
Sets how long the background lighting will remain on. When
operated from the mains power, the background lighting will
always remain on. When operating from the battery pack, the
ARGUS switch off the background lighting after the set time.
Default setting: off after 30 seconds
Software
option
Enabling a software option The associated software key must be
entered via the keypad. 
Additional ARGUS options can be enabled if desired by entering the
associated 20-place code on the keypad.
To obtain this code, please contact us.