Technical data

12 Automatic Test
101
ARGUS 3u plus/3u NT
12.1 Automatic Start test
You should check the required parameters (e.g. BERT
measurement time and error level, see Page 120 and Page
120) before the automatic test series is begun.
Use the< ↓ > to select Start
(in the example, the new test
is saved in record number 2).
Enter Own number - on
accesses using the DSS1
protocol - also enter a
remote number.
Use the < ↓ > to select the
service.
(needed for the
suppl.serv.test)
Start test
During the test series, the
first three lines in the display
will reflect the Single test
currently being run.
To interrupt the test, press
< ABORT >.