Operating instructions

© 2008 Schneider Electric
Parameter
|
Note:
The parameter settings include various
functions which depend on other functions.
Depending on the parameter setting, some
functions or objects may or may not be
displayed in the ETS.
Output for switching/value object X
For each output object you can select between a 1-bit,
1-byte (0% - 100%), 1-byte (0 - 255) and 2-byte object.
The telegram values should be parametrised for the
start of movement and for the end of the movement
time. Here an object can transmit its current value or a
defined value to the bus.
|
Note:
The current value can be transmitted by a time
switch, for example. During the night a lower
byte value is transmitted to the output object of
the movement detector than in daytime hours.
Communication objects
You can select the following communication objects:
Block X general - telegrams - output for switching/
value object X:
Parameter
|
Note:
The parameter settings shown below are
dependent on the operating mode and the
object settings (1 bit, 1 byte or 2 bytes).
Depending on the parametrisation some
parameters will not be displayed!
The parameter settings include various
functions which depend on other functions.
Depending on the parameter setting, some
functions or objects may or may not be
displayed in the ETS.
|
Note regarding 2-byte parameter settings:
Depending on the setting of the object type
value there will be new parameters; depending
on the parametrisation the values can be input
immediately or are determined via sign x basic
value x factor.
Block X, general telegrams
Parameter Setting
Action at start of movement Send immediately
Do not send
Send immediately and then
cyclically
When movement time elapsed Send after staircase timer/
remaining time has elapsed
Do not send
"Send after staircase timer/
remaining time has elapsed and
then cyclically"
Output object X (1 - 4) Enabled
Disabled
Pause between two telegrams (3
- 255) x 100 ms
3 - 255; preconfiguration: 5
Function Object name Type Prio Flags Behaviour
Block X Switch object X 1 bit Low WCT Transmit/
receive
Block X Value object X 1 byte Low WCT Transmit/
receive
Block X Value object X 2
bytes
Low WCT Transmit/
receive
Block X general telegrams
output switching/value object
X
Parameter Setting
Object 1 bit
1 byte 0% - 100%
1 byte 0 - 255
2 bytes
At start of movement Transmits defined value
Transmits its value
Value ON telegram
OFF telegram
0% - 100%
0 - 255
When movement time elapsed Transmits defined value
Transmits its value
Value ON telegram
OFF telegram
0% - 100%
0 - 255
11