Technical data

Chapter 5: ARGUS
5.1 ARGUS movement detector, surface-mounted
INSTABUS ARGUS 220 Connect
Art. no. 6315 ..
Version 03/04 5
4 A: Insert the bus line from behind. Slide the rubber
grommet supplied over the stripped bus line.
B: Insert the bus line from underneath. Cut the rub-
ber insert supplied according to the cable thickness
and place it in the wall connection box. Slide the
bus line through.
5 Install the wall connection box in the intended loca-
tion using the screws and plugs supplied.
Installing the ARGUS on the ceiling
In order to install the ARGUS on the ceiling, you must
rotate the sensor head. Change the direction of rotati-
on once you have reached the end stops.
1 Turn the sensor head upwards until it reaches the
stop.
2 Turn the sensor head clockwise until it reaches the
stop.
3 Align the sensor head.
¼
Risk of damage!
If not installed correctly, the device can be da-
maged by condensation. In the case of sloping
ceilings, mount the device so that the spherical
head points downwards and always at an angle
of 15-90°.
When the spherical head points downwards, water
from condensation could run down the device.
|
Note
The protection rating IP 55 cannot be guaran-
teed if the mounting angle is not 15-90°.
B
A
1
2
3