Installation Guide

ILLUSTRATION B
1. Remove the drain socket ange.
Attach the new wax ring to the bottom
of the drain socket ange.
(See Illustration B.)
2. Reinstall the drain socket ange as
done in Steps 6-7 of “Positioning the
Drain Socket Flange” (on page 4).
3. Attach the water supply line (a
steel braided water supply hose is
recommended) to the tank ller valve
on the toilet.
4. Two people are needed to move the
toilet into place. The tape you placed
earlier shows you where to place the
front of the skirt.
5. Secure the toilet by installing the
screws, plastic cover and decorative
cap into the mounting holes on each
side of the toilet. (These secure the
toilet to the L-mount brackets. See
Illustration C.)
6. Attach the water supply line to the
water supply valve on the wall.
7. Seal the toilet to the oor with silicone
around the bottom edge of the skirt.
NOTE: Do not move the toilet until the
silicone is dry.
INSTALLATION
CONT’D
INSTALLATION OF THE TOILET
ILLUSTRATION C
PAGE 7